THOMSON SpeedTouch 580 Installation And Setup Manual page 22

Chapter 3
Internet Access in No Time
Terminating the Home
Install Wizard
IP settings
20
The SpeedTouch™ Home Install Wizard will configure the SpeedTouch™ and
1
your PC according to the service profile. You can follow the configuration
progress in following window:
Finally, click Finish to close the wizard. After some seconds, the Internet LED
2
will be lit green. If not, refer to
You will be redirected to the embedded SpeedTouch™ pages automatically
3
(unless you cleared the http://speedtouch.lan check box in the previous
window).
These pages allow you to configure your firewall, your wireless access
point settings, and so on. More information can be found in the
SpeedTouch™ User's Guide.
You can test your Internet connection as described in
Internet Connection" on page
The SpeedTouch™ DHCP server is enabled by default. Therefore, during the wizard
the computer's networking interface, used during the Home Install Wizard procedure
is configured for obtaining its IP configuration dynamically.
For fixed IP configurations, please follow the instructions of your ISP.
"5.2 LED Diagnostics" on page
"3.3 Testing your
27.
E-DOC-CTC-20050126-0005 v1.0
33.