THOMSON SpeedTouch 580 Installation And Setup Manual page 14

Chapter 2
Basic Installation
Powering the
SpeedTouch™
12
To turn on the SpeedTouch™, press the power button on the SpeedTouch™ rear
panel.
During the start-up procedure, the power LED on the front panel is lit red for some
seconds. As soon as the power LED is solidly lit green, your SpeedTouch™ is ready
for service. After another couple of seconds, also the DSL LED will light green.
If these LEDs do not light, please refer to
comprehensive LED overview can be found in the SpeedTouch™ User's Guide.
To turn off your SpeedTouch™, press the same button.
"Checking the LEDs" on page
E-DOC-CTC-20050126-0005 v1.0
33. A