Chapter 2
Basic Installation
SpeedTouch™ housing
Wall mount
Stand-up
10
2.1 Installing your SpeedTouch™
The SpeedTouch™ can be mounted on a wall, setup upright or simply be placed as a
desktop.
To mount the SpeedTouch™ on a wall or other vertical surface:
Drill two holes in the wall or other vertical surface where you want to place the
1
SpeedTouch™. Keep a space of 143 millimetres between the two holes.
Fasten two screws in the wall holes. The screws should protrude five
2
millimetres from the surface of the wall.
Attach your SpeedTouch™ on the wall using the two mounting slots on the
3
bottom side.
If you install the SpeedTouch™ onto dry-wall, use dowels to secure the
screws. Otherwise the strain of the cables connected to the
SpeedTouch™ rear panel connectors could pull the SpeedTouch™ from
the wall.
To setup the SpeedTouch™ in an upright position, use the
provided cradle (if available).
E-DOC-CTC-20050126-0005 v1.0