Using The Remote Controller; Manually Tuning A Broadcast Station - Onkyo CR-B8 Instruction Manual

CRB8.book 38 ページ ２００５年８月１８日 木曜日 午後６時４０分
Listening to an FM/AM Station —Continued

Using the Remote Controller

Press the number buttons as
described in the examples
below to select the desired
preset channel.
Preset
Press
channel
8
10
22
represents the tens digit.
Selects an FM/AM station.
Enables you to manually
tune in a broadcast station.
(See the following section.)

Manually Tuning a Broadcast Station

1
1
Turn on the power to the CD receiver.
2
Select FM or AM.
3
Press or repeatedly while observing
the display to tune in the desired frequency.
Each press of the button changes the frequency by
0.05 MHz for FM and 9 kHz for AM. Pressing and
holding down the button for more than one second
will change the frequency continuously.
While FM is selected, pressing and holding
down a while, then releasing it, will automati-
cally raise (or lower) the frequency.
When using the remote controller, press INPUT
to select FM or AM, and press
in the desired frequency.
38
If FM reception is not good
If reception is poor or much noise is heard, press YES/
MODE to turn off the AUTO indicator and switch to
monaural reception. In this way, you can reduce noise or
dropped signals. To return to AUTO tuning, press YES/
MODE again.
2
CD receiver
Remote
YES/MODE
controller
or
/
/ to tune
Adjust the volume level.
(Pressing VOLUME increases
the volume level, and pressing
VOLUME decreases the
level.)
Selects a preset channel.
(Pressing selects a lower
channel number and pressing
selects a higher channel
number.)
AUTO FM ST
SOURCE
SOURCE