Programming Fm Stations Automatically - Auto Preset - Onkyo CR-B8 Instruction Manual

CRB8.book 36 ページ ２００５年８月１８日 木曜日 午後６時４０分
Programming Radio Stations —Continued
Programming FM Stations Automatically – Auto Preset
Auto presets store the frequencies of radio stations into memory so you can select your favorite channels without
tuning manually. Radio station signals can be automatically located and stored. This function does not apply to
AM stations (see page 34).
Display
Turn on the power to the unit before you start the procedure.
Note:
• Auto presetting may store noise instead of a station with a clear signal to some preset channels, depending on your
location. In such cases, erase the preset manually (see page 41).
1 Press INPUT
"FM."
AUTO
SOURCE
To improve the FM reception, adjust the
antenna position.
2
Press EDIT/NO/CLEAR and turn
MULTI JOG to display "AutoPre-
set?"
AUTO
3
Press MULTI JOG.
The confirmation message "AutoPre-
set??" appears in the display.
AUTO
To cancel auto presetting, press EDIT/
NO/CLEAR.
36
1
2
2-4
/ to display 4
Customizing the Preset Channels
The following additional functions are available:
• Naming a preset channel (see page 42)
• Erasing a preset channel (see page 41)
• Copying the radio station in the selected channel to
another (see page 40).
Using the remote controller
Before auto presetting
If any radio stations are preset before you start the
auto preset procedure, they will be replaced with
new presets.
Press MULTI JOG.
Auto presetting starts.
AUTO FM ST
SOURCE
You can preset up to 20 stations. The pre-
set stations will be automatically sorted
in frequency order.
2
2
1
3, 4