Connection For Tv Audio Signal; Connecting An Onkyo Stereo Cassette Tape Deck - Onkyo CR-B8 Instruction Manual

CRB8.book 18 ページ ２００５年８月１８日 木曜日 午後６時４０分
Connecting External Devices —Continued

Connection for TV Audio Signal

Connect the LINE IN terminal on the CD receiver and an audio output terminal on TV.
Tip:
To output sound from TV, switch the input selector to LINE.

Connecting an Onkyo Stereo Cassette Tape Deck

The following diagram illustrates how to connect an optional Onkyo stereo cassette tape deck.
Connect the CD receiver TAPE OUT jacks to the tape deck's INPUT (REC) jacks, and the CD receiver TAPE IN jacks
to the tape deck's OUTPUT (PLAY) jacks.
(The following diagram depicts an example of connection.)
CD receiver's rear panel
: Signal flow
What does connecting an Onkyo stereo cassette tape deck using an
• You can control a connected Onkyo stereo cassette tape deck using the supplied remote controller. You also need to
connect the analog audio cable.
• When the connected Onkyo stereo cassette tape deck plays back, the input selector on the CD receiver is automati-
cally switched to TAPE.
• If a component has two
used to daisy chain with another component.
18
CD receiver's
rear panel
white
red
: Signal flow
red
white
Analog audio cable
(RCA)
white
red
cable supplied
with the Onkyo stereo
cassette tape deck
terminals, you can use either one to connect to the CD receiver. The other one can be
red
Analog audio cable (RCA)
Onkyo stereo cassette
tape deck rear panel
INPUT OUTPUT
(REC)
L
R
white red red
cable enable you to do?
white
REMOTE
(PLAY)
CONTROL
white