Table of Contents
Advertisement
The process described below refers to the mounting kit
mounting for direct and remote mounting. For direct mount-
ing, the travel sensor that is shown is integrated in the hous-
ing of the positioner.
1
2
1. Pull the spindle 2 out of the travel sensor 1.
2. If included, push the guide bush 5 taper over the spindle 2
first.
3. Push the spring 3 over the spindle 2 and secure with the
operating bush 4.
4. Tighten the operating bush 4 by turning it clockwise.
5. Push in the spindle 2 as far as it will go on the spring 3
and then slowly release the pressure on the spring 3.
8.5 Direct mounting to linear actuators
1
2
3
1. Mount the travel sensor mounting kit (see "Linear travel
sensor mounting kit assembly for remote mounting",
page 12).
2. Move the actuator 3 to the open position.
3. Guide the product 1 as far as it will go into the actuator
opening or the adapter, and screw it in in a clockwise dir-
ection against the initial spring tension, and tighten it us-
ing a suitable WAF27 open-ended spanner.
4. Connect the product's pneumatic supply and connect the
product to the process valve.
www.gemu-group.com
1
1
5
2
5
3
2
3
4
4
Damage to internal stop
▶ Do not mount the product by turning the internal stop.
If correctly mounted to the corresponding valve, the product
can be turned 320°.
8.6 Remote mounting to linear actuators
2
3
1. Mount the travel sensor mounting kit (see "Linear travel
sensor mounting kit assembly for remote mounting",
page 12).
2. Move the actuator 3 to the open position.
3. Guide the travel sensor 4 as far as it will go into the actu-
ator opening or the adapter, and screw in in a clockwise
direction against the initial spring tension, and tighten it
using a suitable WAF27 open-ended spanner.
4. Secure the product 1 in a suitable position.
5. The product offers two options for securing:
ð Four fixing holes with threaded sleeves are located on
the rear of the housing, using which the controller can
be installed on holders/routes, etc.
ð An attachment point for a mounting bracket is located
on the underside of the housing. Two different variants
are available as accessories for this. Depending on the
version, the product can therefore be mounted on level
surfaces or on walls.
Mounting bracket for wall mounting
▶ The GEMÜ 1441 000 ZMP mounting bracket, which is
available separately, can be used for this.
13 / 33
NOTICE
1
4
WAF
27
3
NOTICE
GEMÜ 1441 cPos-X
8 Montage
Advertisement
Table of Contents
