Table of Contents
Advertisement
7 Manufacturer's information
7 Manufacturer's information
7.1 Delivery
● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.
7.2 Transport
1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
7.3 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.
8 Montage
8.1 Installation conditions
≥ 10 cm
≥ 10 cm
A clearance of 10 cm must be maintained at the rear of the
device so that the electrical and pneumatic connections re-
main accessible. Furthermore, a vertical clearance of 10 cm
must be maintained to ensure that the unit can be disas-
sembled at any time.
The rear pressure balance openings (right-hand figures) 1
must be maintained (in the event of a malfunction, targeted
venting of the housing is guaranteed by the pressure balance
openings).
GEMÜ 1441 cPos-X
X3
X1
X2
1
12 / 33
8.2 Preparations for mounting to the valve
1. Move the actuator A into zero position (actuator vented).
2. Remove optical position indicator 2 and / or protective cap
1 from the actuator top.
1
8.3 Assembling the adapter (linear actuator)
With some mounting kits it is necessary to install an adapter
as well. This adapter is enclosed with the required mounting
kits. Valves with a normally open and double acting control
function (code 2+3) also include additional O-rings (1+2).
1. Move the actuator to the closed position.
2. Place O-rings 1 and 2 into adapter 3.
3. Screw adapter 3 into the actuator opening as far as it will
go and tighten.
8.4 Linear travel sensor mounting kit assembly for
remote mounting
Pretensioned spring!
▶ Damage to the device.
Slowly release the tension in the spring.
●
Do not scratch the spindle!
▶ A damaged spindle surface may cause failure of the
travel sensor.
Item
1
Travel sensor
2
Spindle
3
Spring
4
Operating bush
5
Guide bush*
6
Threaded adapter**
*Included depending on version
**If a threaded adapter is included, it must be screwed into
the actuator top of the process valve
2
A
1
3
2
CAUTION
CAUTION
Name
www.gemu-group.com
Advertisement
Table of Contents
