Nortel NN43113-106 User Manual page 66

Configuring Local Menu options
Note: Unless you need to dual pair a headset, operating the headset
with the 1140E is simpler if the headset is only used with its charging-
only base. The desktop IP Phone base should be powered off if it is
not in use.
Interaction with wired headsets
If you connect a Bluetooth wireless technology headset and a wired
headset to the same IP Phone 1140E, the two interact as follows:
• If no wireless headset is paired, the wired headset works as normal.
Likewise, if a wireless headset is paired with the set, but is not in
range, the wired headset works as normal.
• If the Use BT headset checkbox is selected, the wireless headset is
used as the phone headset.
The Bluetooth wireless technology headset can work only if it is within
range of the phone; as the wireless headset approaches the edge of its
radio range, the audio quality degrades and radio interference noise
increases. When the wireless headset is in connecting range, the
key controls the wireless headset, even if a wired headset is
Headset
attached. If a wireless headset moves out of connecting range, a special
beep sounds in the headset indicating the connection was lost.
When you do not want to use your Bluetooth technology headset
If a Bluetooth wireless technology headset is connected, and you want to
use the wired headset, you can switch between the two. It is not
necessary to unpair or disable the wireless headset.
You can switch between a wired and wireless headset and back again
either when the phone is idle or during an active call.
To switch between a wired headset and a wireless headset:
(Headset)
66
1. Double-press the
the Bluetooth Setup dialog.
key to open
Headset