Reinstall Components; Step 4: Connect The Grounding Cable - Juniper SRX3600 Getting Started Manual

Step 4: Connect the Grounding Cable

Copyright © 2011, Juniper Networks, Inc.

Reinstall Components

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see the SRX3600 Services Gateway Hardware Guide.
Slide each component into the chassis evenly so that it does not become stuck or
2.
damaged.
Tighten the captive screws or lock any levers for each component installed.
4.
NOTE: Make sure that all empty slots are covered with blank panels before
operating the services gateway.
Proceed to "Step 4: Connect the Grounding Cable" on page 13.
Verify that a licensed electrician has attached the cable lug, provided with the services
1.
gateway, to the grounding cable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Ensure that all grounding surfaces are clean and brought to a bright finish before
3.
making grounding connections.
Connect the grounding cable to a proper earth ground.
4.
Disconnect the ESD grounding strap from the site ESD grounding point.
5.
Connect the ESD grounding strap to one of the ESD points on the chassis. For more
6.
information about ESD, see the SRX3600 Services Gateway Hardware Guide.
Place the grounding cable lug over the grounding point. The grounding point is sized
7.
for M5 screws. See Figure 12 on page 14.
Reinstall Components
13