Power Management Setup - ECS P6VEMT Manual

duplex mode permits simultaneous two-direction transmission. Half-duplex
mode permits transmission in one direction only at a time.
Onboard Parallel Port (378/IRQ7)
This item allows you to determine access onboard parallel port controller with
which I/O address.
Parallel Port Mode (SPP)
EPP
ECP
ECP+EPP
Normal
ECP Mode Use DMA (3)
Select a DMA Channel for the port.
Parallel Port EPP Type (EPP1.7)
This option allows you to select a DMA Channel for the parallel port.

Power Management Setup

The Power Management Setup Menu option is used to change the values of
the chipset registers for system power management.
Phoenix – AwardBIOS CMOS Setup Utility
ACPI function
Power Management
ACPI Suspend Type
PM Control by APM
Video Off Option
Video Off Method
MODEM Use IRQ
Soft-Off by PWRBTN
State After Power Failure
Wake Up Events
↑ ↓ → ← : Move
Enter : Select
Help F5:Previous Values
ACPI Function (Enabled)
This mainboard supports ACPI (Advanced Configuration and Power manage-
ment Interface). Use this item to enable or disable the ACPI feature.
Note: ACPI is a power management specification that makes hardware status in-
formation available to the operating system. ACPI enables a PC to turn its
peripherals on and off for improved power management. It also allows the
Using Parallel Port as Enhanced Parallel Port.
Using the Parallel Port as Extended Capabilities
Port.
Using Parallel Port as ECP & EPP mode.
Supports EPP or ECP mode.
Power Management Setup
[Enabled]
[Press Enter]
[S1(POS)]
[Yes]
[Suspend --> Off]
[V/H Sync+Blank]
[3]
[Instant-Off]
[Off]
[Press Enter]
+/-/PU/PD:Value: F10: Save ESC: Exit F1:General
F6:Fail-Safe Defaults
39
Item Help
Menu Level
F7:Optimized Defaults