ECS P6VEMT Manual page 44

PC to be turned on and off by external devices, so that mouse or keyboard
activity wakes up the computer.
Power Management
This item acts like a master switch for the power-saving modes and hard disk
timeouts. If this item is set to Max Saving, power-saving modes occur after a
short timeout. If this item is set to Min Saving, power-saving modes occur after
a longer timeout. If the item is set to User Define, you can insert your own
timeouts for the power-saving modes.
ACPI Suspend Type (S1(POS))
This item allows you to select the suspend type under ACPI operating system.
PM Control by APM
No
Yes
Video Off Option ( Suspend
This option defines if the video is powered down when the system is put into
suspend mode.
Video Off Method (V/H SYNC+Blank)
This item defines how the video is powered down to save power. This item is
set to DPMS (Display Power Management Software) by default.
Modem Use IRQ (3)
This determines the IRQ, which the MODEM can use.
Soft-Off PWR-BTTN (Instant-Off)
Pressing the power button for more than 4 seconds forces the system to enter
the Soft-Off state when the system has "hung."
State After Power Failure (Off)
This field determines the action the system will automatically take when the
power is restored to a system that had lost power previously without any sub-
sequent manual intervention. There are 3 sources that provide current to the
CMOS are that retains these Power-On instructions; the mainboard battery
(3V), the Power Supply (5VSB), and the Power Supply (3.3V). While AC is not
supplying power, the mainboard uses the mainboard battery (3V). If AC power
is supplied and the Power Supply is turned on, 5VSB from the Power Supply
is used. When the Power Supply is eventually turned on 3.3V from the Power
Supply will be used.
Wake Up Events
If you highlight the literal "Press Enter" next to the "Wake Up Events" label and
then press the enter key, it will take you to a submenu with the following op-
tions:
VGA (Off)
When set to On, the system power will resume the system from a
System BIOS will ignore APM when
Power Management is on.
System BIOS will wait for ROM's prompt
before it enters any PM mode.
Off)
40