ECS P6VEMT Manual page 42

Enable or Disable the MOU-401 function.
MPU-401 I/O Address (330-333H)
Change the SoundBlaster Pro MPU-401 I/O address.
Game Port (200-207H) (Enabled)
Change the joystick connect port addresses.
Init Display First (PCI Slot)
This item allows you to decide to activate the PCI slot or on-chip VGA first.
IDE HDD Block Mode (Enabled)
Enable this field if your IDE hard drive supports block mode. Block mode en-
ables BIOS to automatically detect the optimal number of block read and
writes per sector that the drive can support and improves the speed of access
to IDE devices.
Onboard LAN BOOT ROM (Disabled)
This item allows you to enable or disable the onboard LAN Boot ROM function.
Onboard PCI LAN (Enabled)
Select Enabled if your system contains a built-in PCI LAN controller.
Onboard FDD Controller (Enabled)
Select Enabled if your system has a floppy disk controller (FDC) installed on
the system board and you wish to use it. If install and FDC or the system has
no floppy drive, select Disabled in this field.
Onboard Serial Port 1/2 (Auto)
Select an address and corresponding interrupt for the first and second serial
ports.
Onboard IR Port (Disabled)
Select the IR address.
UART 2 Mode (Standard)
This item allows you to determine which Infrared (IR) function onboard I/O
chip.
IR Function Duplex (Half)
This item allows you to decide to active IR transmission delay.
TX, RX inverting enable (No/Yes)
This item allows you to determine the active of Rx, Tx.
IR Transmission Delay (Enabled)
This item allows you to enable or disable IR transmission delay.
UR2 Duplex Mode (Enabled)
Select the value required by the IR device connected to the IR port. Full-
38