ECS P6VEMT Manual page 27

WOL1: Wake On LAN
If you have installed a LAN card, use the cable provided with the card to plug
into the mainboard WOL1 connector. This enables the Wake On LAN (WOL)
feature. When your system is in a power-saving mode, any LAN signal auto-
matically resumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin Signal Name
1 5VSB
2 GND
3 Ring#
WOM1: Wake On Modem
If you have installed a modem, use the cable provided with the modem to plug
into the mainboard WOM1 connector. This enables the Wake On Modem
(WOM1 feature. When your system is in a power-saving mode, any modem
signal automatically resumes the system. You must enable this item using the
Power Management page of the Setup Utility. See Chapter 3 for more infor-
mation.
Pin Signal Name
1 5VSB
2 GND
3 Ring#
JUSB2: Front USB Headers
The mainboard has four USB ports installed on the rear edge I/O port array.
Additionally, some computer cases have USB ports at the front of the case. If
you have this kind of case, use auxiliary USB connector JUSB2 to connect the
front-mounted ports to the mainboard.
Pin Signal Name
1 +5V
3 USB1 Data (-)
5 USB1 Data (+)
7 Ground
9 Key
LUSB1: Front USB Headers
Pin Signal Name
1 +5V
3 USB0-
5 USB0+
7 Empty
9 Ground
Function
+5V stand by power
Ground
Wake up signal (high active)
Function
+5V stand by power
Ground
Wake up signal (low active)
Pin Signal Name
2 +5V
4 USB2 Data (-)
6 USB2 Data (+)
8 Ground
10 Na
(for OEM customers only)
Pin Signal Name
2 Ground
4 Empty
6 USB1+
8 USB1+
10 +5V
23