Power Management Setup Page - ECS P4S8A Manual

Mainboard User's Manual
DRAM CAS# Latency
Timing Setting Mode
MA 1T/2T Select
Hyper Threading
Function
Auto detect
DIMM/PCI Clk
Spread Spectrum
DOS Flat Mode

Power Management Setup Page

This page sets some of the parameters for system power
management operation.
AMIBIOS SETUP – POWER MANAGEMENT SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
ACPI Aware O/S
Power Management
Suspend Time out
Hard Disk Time out
Resume On RTC Alarm
RTC Alarm Date
RTC Alarm Hour
RTC Alarm Minute
RTC Alarm Second
LAN/Ring Power On
Keyboard Power On
28
This item determines the operation of DRAM
memory CAS (column address strobe). It is
recommended that you leave this item at the
default value. The 3T setting requires faster
memory that specifically supports this mode.
This item determines the timing setting mode
of the memory. We recommend you leave
this item at the default value.
This item adjusts timing 1T/2T latency. We
recommend you to leave this item at the
default value.
If your P4 CPU is not HT CPU, this item will
be hidden. If your P4 CPU is HT CPU, BIOS
will show this item. You can set "Disabled" or
"Enabled" to control HT CPU support in O.S.
Set "Enabled" to test HT CPU function.
When this item is enabled, BIOS will disable
the clock signal of free DIMM/PCI slots.
If you enable spread spectrum, it can
significantly reduce the EMI(Electro-Magnetic
Interference) generated by the system.
This item enables BIOS to enter the DOS
protected mode without other software
supporting under the DOS operating system.
We recommend you leave this item at the
default value.
Yes
Enabled
Disabled
Disabled
Disabled
ESC : Quit
15
12
F1 : Help
30
F5 : Old Values (Shift)F2 : Color
30
Disabled
F6 : Load BIOS Defaults
Disabled
 : Select Item
PU/PD/+/- : Modify