Table of Contents
Advertisement
MicroHarmony Cell Sizes 40 - 260A Manual
1.2 Features
1.2.1
Cell Racking System
No hardware is required for mounting the cells in place within the drive.
The MicroHarmony cell is designed to be mounted on polyethylene coated mounting rails. The cell is equipped with
two locking latches on each side that latch into the mounting rail. The latches provide rear power plug alignment and
cell mounting. The latches are then rotated clockwise to pull the cell into place. Once the latches are in the vertical
position, the cell is properly aligned and locked into place. To remove, the latches are pulled back down to the
horizontal position.
High temperature foam forms an air tight seal between the cell chassis and backplane at the rear of the cell (not
shown).
1.2.2
Rear Blind-Mate Power Connections
No hardware is required for making the cell's input and output power connections.
Connections are made via blind-mate power plugs at the rear of the cell. The system is designed to tolerate as much
as 6 degrees of misalignment in all directions. The locking latches and mounting rails provide alignment.
19001467: Version 1.0
s
Cell Overview
1
1-3
Advertisement
Table of Contents
