Table of Contents
Advertisement
9490 Operator's Handbook
4. Remove the used ribbon and take-up reel and discard.
Do Not wrinkle or crush the ribbon.
n
5. With the ridged end of the take-up reel facing down, place
6. Feed the ribbon around the guides and place the take-up
7. Twist the ribbon roll back and forth as you firmly push it
✦
Do Not force the ribbon roll down onto the spool; you could
n
damage the foam washer.
✦
Make sure the preprinted side of the ribbon faces out.
✦
Make sure the latches are still in the unlocked position
✦
If you are using a 2-inch or 3-inch-wide ribbon, push the
core of the ribbon roll to seat the ribbon roll onto the
cassette's spool. Do not touch the ribbon because it may
wrinkle and twist.
8. Replace the other half of the cassette. The two halves
9. Check to make sure that the ribbon is loaded correctly; the
10. If the ribbon does not advance, or if it is hard to turn the
2-6
All manuals and user guides at all-guides.com
Open a package of new ribbon.
the ribbon roll on the spool with the foam washer (on the
half of the cassette with the latches). Do not push the
ribbon roll down onto the spool yet.
reel onto the shorter spool.
down until it is seated on the spool.
( ) before fitting the two halves of the cassette together.
should fit together completely. Rotate the latches until
they click into the closed position (
ribbon should be wound tightly inside the cassette. Turn
the gear counterclockwise with your fingers until the black
portion of the ribbon is exposed.
gear, repeat the loading procedure.
TC9490OH Rev. C 3/97
).
Advertisement
Table of Contents
