Table of Contents
Advertisement
TOOLS REQUIRED FOR ASSEMBLY (NOT
INCLUDED):
•
Flat Head Screwdriver
•
Phillips Head Screwdriver
•
8mm Wrench
•
10mm Wrench
•
12mm Open-Ended Wrench
•
13mm Wrench
DO NOT lift Saw without help. Hold it close to your body
•
while lifting. KEEP knees bent and lift with your legs, not your
back.
•
Fully assemble Saw with Leg assembly prior to use. Leg
assembly is an integral and necessary part of the Support
Structure for this Saw.
•
DO NOT modify Saw, or create accessories not recommended
for use with this Saw.
•
Make sure Power Switch is in "OFF" position before connecting
to Power Supply.
•
DO NOT connect to Power Supply until assembly is complete.
Avoid contact with Blade Teeth. KEEP
Blade stored or lowered when possible.
STAND
Hardware Bag "A"
1.
Connect the two Tube Legs together by inserting the end
of the Left Leg
PC2
Secure them together with (4) M8 x 75mm Carriage Bolt
, M8 Flat Washer
HP4
See Figure 1.
2.
Insert the four open ends of the Tube Legs into the Leg
Collars
as shown. Secure each Leg to the Saw Body
A
with (4) M6 x 72mm Carriage Bolts
Nuts
and tighten. See Figure 2.
HP5
FIXED WHEELS AND STATIONARY
FEET
Hardware Bag "B"
1.
Attach the two Fixed Wheels
(2) M8 x 53mm Carriage Bolts
. One for each wheel as shown in Figure 3.
HP2
2.
Screw the Adjustable Feet
the Right Leg.
3.
Carefully stand the box right side up and remove packaging
once the machine has been lifted from the ground.
The machine is heavy, two people may
be required to stand the machine up.
4.
The two Adjustable Feet
rotating them clockwise or counterclockwise. The Feet
may be adjusted to level the Saw and can be locked in
place with the pre-assembled Set Screws using the
provided 6mm Allen Wrench. See Figure 3.
ASSEMBLY
•
9/16 inch Wrench
•
5/32 inch Allen Wrench
•
Framing (Carpenter's) Square
•
Combination Square
•
Straight Edge
into the end of the Right Leg
, M8 Nylock Nut
and tighten.
HP3
HP2
and (4) M6 Nylock
HP4
to the Left Leg using the
PC13
and M8 Nylock Nuts
HP6
into the threaded inserts in
PC12
can be raised and lowered by
PC12
PC3
HP3
HP2
.
PC3
PC12
14
HP1
PC2
Figure
1
A
Figure 2
HP2
PC13
HP6
Figure 3
Figure 4
Advertisement
Table of Contents
