Mounting The Saw To Astable Surface; Assembly; Attaching Mitre Lock Knob; Attach Work Clamp - Delta ShopMaster S26-262LS Instruction Manual

MOUNTING AND TRANSPORTATION
MOUNTING THE SAW TO A
STABLE SURFACE
To ensure safe and accurate operation,
this saw should be mounted to a stable
and level surface such as a workbench. To mount the tool
to a stable surface, refer to Figure 5 and do the following:
1. Locate the four mounting holes in the base of the saw
(A).
2. Secure the tool to the mounting surface using 3/8"
diameter machine bolts, lock washers, and hex nuts
(not included). Make sure the bolts are long enough to
accommodate the saw base, lock washers, hex nuts,
and the thickness of the workbench.
3. Tighten all four bolts securely.
4. Check to make sure that the saw is secure before
operation.
• Do not attempt to modify this tool or create accessories not recommended for use with this tool.
Any such alteration or modification is misuse and could result in a hazardous condition.
• Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting.
• Do not start the mitre saw without checking for interference between the blade and the mitre fence. Damage could result
to the blade if it strikes the mitre fence during operation of the saw.
• This saw can tip over if the saw head is released suddenly and the saw is not secured to a work surface. ALWAYS secure
this saw to a stable work surface before any use.
• If any parts are damaged or missing do not operate this tool until the parts are replaced. Please call Customer Care
Center at 800-223-7278, for instructions.

ATTACHING MITRE LOCK KNOB

1. See Figure 6 and attach the mitre lock knob by
screwing the end of the mitre lock handle (B) into
the threaded hole (C) in the control arm. Tighten by
rotating the lock knob clockwise.
A
A

ASSEMBLY

10
FIGURE 5
B
C
FIGURE 6
A
A
TIGHTEN