Software Token Update - Graco King E60 Operation

Software Token Token Update
Software Software Token
To help prevent fire and explosion, do not
connect, download, or remove the token unless
the unit is removed from the hazardous (explosive
atmosphere) location.
1. Turn the disconnect switch OFF. Remove power
from the unit.
2. Use a 6 mm hex wrench to remove four bolts.
Remove the motor cover.
3A8124A
Update
Update
3. Insert and press the token firmly into the token
connector slot. NOTE: NOTE: The token requires no NOTE:
specific orientation.
4. Reinstall the motor cover.
5. Apply power and turn the disconnect switch ON.
6. Monitor the Status Indicator Light (L) for the
status of the software update.
a. The Status Indicator Light will blink slowly for
a few seconds and then rapidly for several
seconds.
b. Once the update is complete, the unit
will power up and flash out the software
version. Three numbers will be flashed
out to convey the software version in
the format of x.yy.zzz. For example:
"flash-pause-flash-flash-pause-flash-pause"
would indicate that software version is
1.02.001 installed.
7. The unit will flash out the software version every
time the unit is powered up while the software
token is present. The token can remain in place
even after the software has been updated, but
can optionally be removed.
8. Contact Graco Technical Support for the latest
software version for each system.
Repair
13