Driver Operation; Pressure Control; Maintenance; Preventive Maintenance Schedule - Graco King E60 Operation

Driver Operation

Operation
Driver Driver Operation

Pressure Control

Control
Pressure Pressure Control
The driver will adjust the speed to maintain a constant
fluid pressure.
1. Pull the Pressure Control Knob (N) out to set.
2. Turn the Pressure Control Knob (N) fully
counterclockwise to 0.
3. Turn the knob clockwise to increase the pressure,
or counterclockwise to decrease the pressure.
Push the knob in to lock.

Maintenance

Maintenance Maintenance
Preventive Preventive Maintenance Preventive Maintenance Schedule Maintenance
The operating conditions of your particular system
determine how often maintenance is required.
Establish a preventive maintenance schedule by
recording when and what kind of maintenance is
needed, and then determine a regular schedule for
checking your system.
Change the the Oil Oil
Change Change the Oil
NOTE: Change the oil after a break-in period of
NOTE: NOTE:
200,000–300,000 cycles. After the break-in period,
change the oil once a year. Order two bottles of
Silicone-Free Synthetic ISO 220 EP Gear Oil (Graco
Part No. 16W645).
1. Place a minimum 2 quart (1.9 liter) container
under the oil drain port. Remove the oil drain
plug (G). Allow all oil to drain from the driver.
2. Reinstall the oil drain plug (G). Torque to 18–23
ft-lb (25–30 N•m).
NOTICE
NOTICE NOTICE
Do not over-torque. The drain plug can
become stripped and damaged.
3A8124A
3. Open the fill cap (P) and add Graco Part No.
4. Reinstall the fill cap.
Schedule Schedule
Check Oil Check Check
Check the oil level in the sight glass (K). The oil level
should be near the halfway point of the sight glass
when the unit is not running. If low, open the fill cap
(P) and add Graco Part No. 16W645 Silicone-Free
Synthetic ISO 220 EP Gear Oil as required. The oil
capacity is approximately 1.0–1.2 quarts (0.9–1.1
liters). Do
Bearing Pre
Bearing Bearing
The bearing pre-loads (R) are factory set and are not
user adjustable. Do not adjust the bearing pre-loads.
16W645 Silicone-Free Synthetic ISO 220 EP
Gear Oil. Check the oil level in the sight glass (K).
Fill until the oil level is near the halfway point of
the sight glass. The oil capacity is approximately
1.–1.2 quarts (0.9–1.1 liters). Do
NOTICE
NOTICE NOTICE
Only use Graco GBL oil (Graco part number
16W645). Any other oil may not lubricate
properly and can cause damage to the drive
train.
Oil Level Oil Level Level
Do not Do not overfill. not overfill. overfill.
Pre - - - Load Load
Pre Load
Driver Operation
Do not Do not overfill. not overfill. overfill.
9