Table of Contents
Advertisement
Setup
Loose Parts
Note: Use the chart below to identify parts for assembly.
Description
Frame
Vinyl Cover
Bolts, 1/4 x 1-1/4 in.
Backhoe Kit for a 200/300 Series traction unit
(sold separately)
Backhoe Kit for a TX Series traction unit (sold
separately)
The backhoe mounts slightly differently to the 200/300 series traction unit than it does to the TX. You must obtain and install
the Backhoe kit appropriate for your traction unit. Use the instructions provided in this section to install these kits.
Installing the Heat Shield
1. Place the vinyl cover on the underside of the frame and
secure it around the rods with the hook and loop
fasteners (Fig. 1).
4
5
3
Figure 1
1. Vinyl cover
2. Frame rods (not covered
by vinyl cover)
3. Bolts and nuts (not
shown) at the rear of the
platform
Qty.
1
2
m-6440
4. Seat stand
5. Operator platform
1
1
Install the heat shield
2
1
One kit required to connect the backhoe to your
traction unit
1
2. Remove the seat and the seat bracket from the seat
stand.
3. Remove the 2 bolts and 2 nuts at the rear of the operator
platform (Fig. 1). Discard the bolts but save the nuts for
step 5.
4. Place the heat shield down over the seat stand (Fig. 1).
5. Use the 2 bolts from the kit (1/4 x 1-1/4 in.) and the
2 nuts (1/4 in.) that you removed in step 3 to secure the
tabs at the base of the heat shield to the operator
platform.
6. Install the seat.
7
Use
Advertisement
Table of Contents
