Furuno FAR-2117 Installation Manual page 51

TT PRESET menu setting
Open the TT PRESET menu by pressing [6] key on the INITIALIZE menu.
[TT PRESET]
1 BACK
2 TT DATA OUTPUT
OFF/TTM/TTD
REL/TRUE
4800/9600/
19200/38400
3 MAX RANGE
24/32
4 ECHO LEVEL
16
5 QV DISPLAY
OFF/ON
6 TT W/O GYRO*
OFF/ON
7 [TT PRESET]
8 [TRACK PRESET]
9 [TT SENSOR DATA]
0 DEFAULT
*: Not on IMO radar
TT DATA OUTPUT
Set the output format from J619 (sentence, bearing and baud rate) of tracked targets.
Sentence: (OFF: No output, TTM: Tracked target information, TTD: Tracked target data)
Bearing: REL: Target bearing from own ship, degree relative,
TRUE: Target bearing, degree true, target course, degree true.
Baud rate: (4800, 9600, 19200 or 38400 bps)
NOTE: The TT DATA OUTPUT port changes according to the setting for INS as described
on page 3-15.
INS-OFF:
INS-SERIAL:
INS-LAN:
MAX RANGE
Choose the target tracking range, 24 or 32 nm.
ECHO LEVEL
Set the detection level of echoes. The setting range is 1 to 31.
QV DISPLAY
OFF: Normal picture
ON: Quantized picture; always off at power on
[TT PRESET]
1 BACK
2 LAND SIZE
1600 M
3 ANT SELECT
XN12AF/XN20AF/
XN24AF/XN4A/XN5A
SN30AF/SN36AF/
SN4A/SN5A
4 AUTO ACQ CORRE
5 SCAN
5 AUTO ACQ WEED
1 SCAN
6 [TT DETAIL DATA]
target course, degree relative.
Output from J619 port only
Output from J619 and J620 (TTM only) ports
Output from J619 and NETWORK (TTM only) ports
3. SETTING AND ADJUSTMENT
[TRACK PRESET]
1 BACK
2 GATE SIZE
S/ M /L/LL
3 FILTER RESPONSE
1/ 2 /3/4
4 LOST COUNT
9 SCAN
5 MAX SPEED
100 KTS
6 TRACKING MODE
1 /2/3/4
7 START TIME TGT VECT
TIME /SCAN
50 SEC
20 SCAN
3-13