Processor Unit - Furuno FAR-2117 Installation Manual

1.4

Processor Unit

Mounting considerations
When selecting a mounting location, keep in mind the following points:
• Locate the processor unit away from heat sources because of heat that can build up
inside the cabinet.
• Locate the equipment away from places subject to water splash and rain.
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
• A magnetic compass will be affected if the processor unit is placed too close to the
magnetic compass. Observe the compass safe distances on page ii to prevent deviation
of a magnetic compass.
Mounting procedure
1. Fix the unit with four M6 bolts, or self-tapping screws.
Note: If you fix the unit, cable entry upside, never remove the screw M3x10 that joints
the upper case assy. and lower case assy. of the processor unit.
385
370±1
350±1
Floor mounting or bulkhead mounting
Upper case assy.
Lower case assy.
Screw
M3x10
Never remove this screw.
Processor unit
2-φ7 FIXING HOLES
7
2-FIXING NOTCH
1. MOUNTING
1-15