Dual Radar Display (Non Imo-Type Only) - Furuno FAR-2117 Installation Manual

Marine radar/arpa
Hide thumbs Also See for FAR-2117:
Table of Contents

Advertisement

3. SETTING AND ADJUSTMENT
3.7

Dual Radar Display (non IMO-type only)

The image from both X-band and S-band radars may be shown together on one radar
display. This allows you to take advantage of the best characteristics each type of radar has
to offer. Two display formats are available, mixed and combine, and you may select desired
format from the menu.
The following should be done in order to enable the dual radar display:
Set antenna position correctly on both the main radar and the external radar.
Select external radar to use, from the DUAL RADAR menu. (See paragraph
3.7.3.)
3.7.1
Enabling/Disabling the Dual Radar Display
Enable or disable the dual radar display as shown in this section.
Note 1: The Tx blanking sector boundary lines are not shown when the dual radar display is
active. Further, neither the internal or external image is shown in the Tx blanking
sector.
3-16
External image overlaid on
internal image ("MIX" setting)
Tx blanking sector
Tx blanking sector
Image from main radar
Image from
external radar
Separate internal and external
images ("COMBINE" setting)
Tx blanking sector not shown.
No image in Tx blanking sector.
Dual radar display with
Tx blanking sector
Display area

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Far-2117-bbFar-2127Far-2127-bbFar-2817Far-2827

Table of Contents