Specifying Sector Width And Length - Furuno FAR-2117 Installation Manual

3.7.2

Specifying Sector Width and Length

When 2 DUAL RADA R in the DUAL RADAR menu is set for "COMBINE", specify
the width and length o f the sector from the external radar to display on own radar.
1. Open the INITIALIZE menu.
2. Press the [3] key to show the SCANNER menu.
3. Select 9 [DUAL RADAR] and push the left button.
4. Select 3 COMBINE MODE and push the left button.
5. Select OWN or EXT and push the left button.
OWN: Set own radar's antenna as reference point and set display area of own
EXT: Set external radar's antenna as reference point and set display area of
Radar selected for COMBINE: External
START:
ANGLE:
START:
LENGTH: 99.99 nm
6. Select 4 COMBINE SECTOR and push the left button.
radar. The area outside that set here is where the image from the
external radar will be displayed.
external radar. The area outside that set here is where the image from
own radar will be displayed.
315 degrees
90 degrees
00.00 nm
3. SETTING AND ADJUSTMENT
Radar selected for COMBINE: Own
START:
ANGLE:
START:
LENGTH: 99.99 nm
Picture from
external radar
Position of antenna
for external radar
Position of antenna
for own radar
Picture from
own radar
45 degrees
270 degrees
00.00 nm
3-19