Setting Destination - Furuno GP-1610CF Operator's Manual

SETTING DESTINATION

8.1 Setting Destination
The GP-1610CF offers four methods by which
you can set destination:
• Previously entered waypoint
• Cursor position
• Event position/MOB position
• Route
Setting destination by waypoint
1. Press the GOTO key. The following
menu appears.
SELECT GOTO MODE
WPT List
EVENT List
ROUTE List
Cursor/Route plan
ENT: Sel
Figure 8-1 Destination waypoint
selection menu
2. Press the GOTO key again to select WPT
List.
3. Press the ENT key. The waypoint list ap-
pears.
WAYPOINT LIST
No. LAT/LONG
2 3 0 0 . 0 0 0 ' N
0 0 1
1 2 3 0 0 . 0 0 0 ' E
3 2 2 1 . 1 2 8 ' N
0 0 2
1 3 5 2 7 . 9 2 3 ' E
3 0 1 2 . 3 4 5 ' N
0 0 5
1 2 7 2 1 . 2 9 3 ' E
: Cursor
ENT: Set
*: In Use
Figure 8-2 Waypoint list
CLR: Release
ESC: Cancel
COMMENT
10MAR97 01_ _
10MAR97 01_ _
10MAR97 01_ _
: Page change
CLR: Release
MENU: Sel Mode
4. Operate or
5. Press the ENT key.
• A dashed light-blue line runs between des-
tination selected and own ship's position.
• The range and bearing to the destination
appear at the bottom of the display.
01
00
WP001 0 10nm
CSE 10.0 SPD 16.8kt
DEP 110m TMP 16.0 C 14:30
POS 34 26.345'N 135 41.232'E
Figure 8-3 Appearance of display when
destination is selected by waypoint
Setting destination by cursor
1. Press the GOTO key.
2. Press the GOTO key to select Cursor/
Route plan.
3. Press the ENT key.
: Cursor
ENT: Set
ENT twice: complete
MENU: SEL Mode
4. Place cursor on position desired for des-
tination.
5. Press the ENT key. To set a single desti-
nation, go to step 7. To set more than one
destination, go to step 6.
6. Repeat steps 4 and 5 to enter other desti-
nations.
7. Press the ENT key.
to select a waypoint.
Destination
Course
Own ship's
position
Bearing and range
to destination
2D
8-1