Furuno GP-1610CF Operator's Manual page 30

1-20
Transom mount water temperature sensor
T-02MTB
• Fix the cable at a convenient location with cable clamp.
• When the cable is led in through the transom board, make a
hole of approx. 17 mm diameter to pass the connector. After
passing the cable, fill the hole with a sealing compound.
D
D>50 cm
M5 x 20
Figure 1-27 How to install transom mount water temperature
sensor T-02MTB
Thru-hull mount water temperature sensor
T-03MSB
• Select a mid-boat flat position. The sensor does not have to be
installed perfectly perpendicular. The sensor must not be dam-
aged in dry-docking operation.
• Select a place apart from equipment generating heat.
• Select a place in forward direction viewing from the drain hole
for cooling water.
• Select a place free from vibration.
1. Dry-dock the boat.
2. Drill a hole of 25 mm in the hull.
3. Pass the sensor cable through the hull.
4. Pass the rubber washer, washer and locknut onto the cable in
that order.
5. Apply high grade sealant to the sensor flange, sensor and lock-
nut. Tighten the locknut. Do not overtighten it.
6. Launch the boat and check for water leakage around the sen-
sor.
Mount sensor
flush with hull bottom.