Changing Waypoint Mark Size; Entering Routes - Furuno GP-1610CF Operator's Manual

Note: If the waypoint selected is part of a
route you are asked whether it is alright to
edit the waypoint.
ROUTE IN USE
ROUTE DELETE
DELETE?
ENT: YES
ENT: YES
ESC: NO
ESC: NO
When route is in use
7. Press the ENT key to register changes.
8. Press the MENU key to escape.
7.4 Changing Waypoint Mark
Size
Waypoint mark size can be selected to large
or small.
Large
01
Figure 7-9 Waypoint mark size
l. Press the MENU key.
2. Press the [l] key to show the DISPLAY
SETUP menu.
DISPLAY SETUP
HUE 1
LAND BRILL BRT
LAND COLOR
RED YEL GRN BLU PPL WHT OFF
PLACE NAME
RED YEL GRN BLU PPL WHT OFF
GRID COLOR
RED YEL GRN BLU PPL WHT OFF
COURSE BAR
RED YEL GRN BLU PPL WHT OFF
TIME MARK
RED YEL GRN BLU PPL WHT OFF
WPT MARK SIZE
L
CURSOR SIZE
L
: Cursor
Figure 7-10 Display setup menu
3. Operate the Cursor Pad to select WPT
MARK SIZE.
4. Operate the Cursor Pad to Large or Small.
5. Press the MENU key to register selection.
7-4
Small
2
DIM OFF
S
S
ESC: Esc

7.5 Entering Routes

Often a trip from one place to another involves
several course changes, requiring a series of
route points (waypoints) which you navigate
to, one after another. The sequence of
waypoints leading to the ultimate destination
is called a route. The GP-1610CF can auto-
matically advance to the next waypoint on a
route, so you do not have to change the desti-
nation waypoint repeatedly.
You can store up to 20 routes. A route may
consist of 30 points.
A route is constructed using waypoints, there-
fore enter waypoints beforehand.
1. Press the MENU key.
2. Press the [4] key to display the route/route
list.
ROUTE LIST
No. PTS
TOTAL
0 1 6
3 0 2 . 1 1 nm
0 2 4
2 0 1 . 2 7 nm
: Cursor
CLR : Delete Route
*: In Use
Figure 7-11 Route list
3. Press or to select route number.
TTG
4 1 : 3 6
3 5 : 5 2
ENT: Sel
ESC: Esc