Presentation Mode; Shifting The Cursor - Furuno GP-1610CF Operator's Manual

4.2 Presentation Mode

Two types of display presentations are pro-
vided for the plotter display and plotter/
sounder display: north-up and course-up. You
can select one with the NU/CU key.
North-up
North (zero degrees) is at the top of the dis-
play and own ship is at the center of the screen.
This mode is useful for long-range naviga-
tion.
CSE 340.0 SPD 16.8kt
DEP 110m TMP 16.0 C 14:05
POS 34 26.345'N 135 41.232'E
Figure 4-4 North-up display
Course-up
When destination is set it is at the top of the
screen, the north mark appears at the lower
left side of the screen and points to north. A
triangle marks own ship's position.
North
mark
WP001 0 10nm
CSE 10.0 SPD 16.8kt
DEP 110m TMP 16.0 C 14:08
POS 34 26.345'N 135 41.232'E
Figure 4-5 Course-up display
Own ship
mark
2D
Destination
01
Own ship
mark
Bearing and
range to
2D
waypoint

4.3 Shifting the Cursor

l. Press the CURS key to turn the cursor on.
2. Operate the Cursor Pad. The cursor moves
in the direction the Cursor Pad is pressed.
When the cursor reaches an edge of the
screen, the display is scrolled.
Bearing and
BRG+ 132.0 RNG+ 5.0mm 2D
range from
DEP 110m
own ship + 32 10.523'N 133 27.254'E
to cursor
Figure 4-6 Plotter display, showing
location of cursor data
When the cursor is turned off, own ship data
is shown instead of cursor data.
Course,
CSE 340.0 SPD 16.8kt
DEP 110m TMP 16.0 C 14:05
speed
POS 34 26.345'N 135 41.232'E
Figure 4-7 Plotter display, showing
location of own ship's data
Own ship
mark
Cursor
(Size can
be selected
to large or
small. Size
TMP 16.0 C 14:05
shown is
large.)
Cursor position
in latitude and
longitude
Own ship
mark
2D
Position
4-3