Marks; Entering Marks; Entering Event Marks - Furuno GP-1610CF Operator's Manual

MARKS

6.1 Entering Marks

You can inscribe marks on the plotter display
to denote important locations; for example,
buoy, fishing point, wreck, etc. Further, marks
can be connected with lines to depict an area
such as a hot fishing spot.
100 marks may be entered. When the mark
memory is full the oldest mark is deleted to
make room for the latest.
Entering a mark at ship's position
1. Press the CURS key to turn off the cur-
sor.
2. Press the EVENT MOB key. The mark
currently selected on the TRACK/MARK
SETUP menu appears at own ship's posi-
tion.
Entering a mark at cursor intersection
1. Press the CURS key to turn on the cursor.
2. Press the EVENT MOB key. The mark
currently selected on the TRACK/MARK
SETUP menu appears at the cursor inter-
section.

6.2 Entering Event Marks

The event mark denotes a point of interest at
own ship's position.
100 event marks may be entered. When the
event mark memory is full the oldest event
mark is deleted to make room for the latest.
Enabling entry of an event mark
To enable entry of an event mark do the fol-
lowing:
1. Press the MENU key.
2. Press the [0] key to select SYSTEM
MENU.
SYSTEM MENU
1. SELF TEST
2. PLTR SETUP
3. SOUNDER SETUP
4. UNIT SETUP
5. SENSOR SETUP
6. NMEA SETUP
7. GPS SETUP
8. DGPS SETUP
9. CHART POSN CALIB
: Cursor
ENT: Sel
Figure 6-1 System menu
3. Press the [2] key to select PLTR SETUP.
PLTR SETUP
OWN
NAVAID
SCALE
SCALE
SMOOTHING 00 (00~15)
00 min
SPD AVERAG
TRUE
BEARING
AUTO
MAG CALIB
06.3 W
EVNT METHOD EVENT
L/L
POSITION
LC
DISP
Chain: Sec 7970: 11-26
LOP CALIB
+000.0 s
+000.0 s
: Cursor
Figure 6-2 Plotter setup menu
4. Press or to select EVNT METHOD.
5. Press t to select EVENT.
6. Press the MENU key.
Entering an event mark
Press the EVENT MOB key. An event mark
is entered at own ship's position.
ESC: Esc
LC DE ALL
RANGE
MAG
MAN
00.0 E
MARK
LOP
DE
: E/W, +/-
ESC: Esc
6-1