Furuno GP-1610CF Operator's Manual page 25

Acceptable transducer mounting locations
Deep-V hull
• Position 1/2 to 1/3 length of the hull from stern
• 15 to 30 cm off center line (inside first lifting strakes).
Figure 1-19 Transducer mounting location on deep-V hull
High speed V-planing hull
• Within the wetted bottom area
• Deadrise angle within 15
Figure 1-20 Transducer mounting location on high speed
V-planing hull
Typical through-hull mount transducer installations
Fairing block
Deep-V Hull
Figure 1-21 Typical through-hull mount transducer installations
Flat washer
Rubber washer
Hull
bottom
Hull
bottom
Flat Hull
1-15