Mounting, Wiring; Preparation - Furuno MU-150HD Operator's Manual

1.

MOUNTING, WIRING

1.1

Preparation

Mounting type
You can install the display unit as follows. See the outline drawing at the back of this manual for
mounting dimensions.
• Flush mounting, fixed at rear (standard)
• Flush mounting, fixed at front (option)
• Flush mounting, fixed at rear, with hood (option)
• Desktop mounting (option)
• Flush mounting a series side by side, fixed at rear
Note: The face of the LCD monitor is made of glass. Handle it with care.
Mounting location
When you choose a mounting location, remember the following points:
• Make sure the mounting location is strong enough to support the weight of the unit.
• Locate the unit away from direct sunlight. An LCD may black out if it is exposed to direct sunlight
for a long time.
• Select a location where the display can be easily viewed and the controls can be easily operat-
ed.
• Leave enough space around the unit for service and maintenance. See the outline drawing at
the back of this manual for minimum service clearance.
• Locate the unit away from areas subject to water splash and rain.
• Observe the compass safe distances (see page iii) to prevent interference to a magnetic com-
pass.
How to remove/attach the hard cover
Before you install this display unit, remove the hard cover as follows.
CAUTION CAUTION
When lifting the display unit, hold it
together with the hard cover.
Grasping by the hard cover alone may
allow the display unit to fall, resulting in
possible bodily injury or damage to the
equipment.
1