Mounting, Wiring; Preparation - Furuno MU-190V Operator's Manual

1.

MOUNTING, WIRING

1.1

Preparation

Mounting method
There are three methods to mount the monitor unit. See the outline drawing at the back of this
manual for mounting dimensions.
• Flush mount, fixed at rear (standard)
• Flush mount, fixed at rear, with hood (option)
• Tabletop mount (option)
Note 1: The face of the LCD monitor is made of glass. Handle it with care.
Note 2: For flush mount, take care so that the monitor unit does not fall during the installation.
Mounting location
Select a mounting location, considering the following points. This equipment is free from electro-
magnetic fields.
• Make sure the mounting location is strong enough to support the weight of the unit.
• Locate the unit away from direct sunlight. An LCD may darken if it is exposed to direct sunlight
for a long time.
• Select a location where the display screen can be easily viewed and the controls can be easily
operated.
• Leave enough space around the unit for service and maintenance. See the outline drawing at
the back of this manual for minimum service clearance.
• Locate the unit away from areas subject to water splash and rain.
• Observe the compass safe distances (see page iii) to prevent interference to a magnetic com-
pass.
Run cables before installing the monitor unit
Run all cables before you install the monitor unit. See the interconnection diagram at the back of
this manual.
1