How To Change The Signal Name - Furuno MU-150HD Operator's Manual

2.3.2

How to change the signal name

You can change the signal name ("RGB", "DVI1" or "VIDEO1" etc.) to a name (ex. the equipment
name) which is easy to understand. The changed name is shown in the DISP selection window,
PIP selection window and the indication shown at the upper right of the screen. See section 3.4
and section 3.5
1. Press the MENU key to show the main menu.
2. Press the or
Signal
name area
3. Press the or
example above, RGB is selected.
4. Press the key to select the character to change. In the example below, "G" of RGB is se-
lected.
5. Press the or
"5" is selected.
You can set up to ten characters. "A to Z", "0 to 9", "–", ".", " " (space) are available.
6. To change another signal name, press the
nal name area. Repeat steps 3 to 5.
7. Press the MENU key to close the menu.
key to select [OSD].
RGB DVI1 DVI2 VIDEO1 VIDEO2 VIDEO3
H_POSITION
V_POSITION
TRANSLUCENT
PIP SW TIME
PIP SKIP
CUSTOM NAME
RGB = RGB
DVI1 = DVI1
DVI2 = DVI2
VIDEO1 = VIDEO1
VIDEO2 = VIDEO2
VIDEO3 = VIDEO3
Signal name area
key to select the signal to change its name in the signal name area. In the
CUSTOM NAME
RGB
DVI1
DVI2
VIDEO1
VIDEO2
VIDEO3
key to select appropriate alphanumeric character. In the example below,
CUSTOM NAME
RGB
DVI1
DVI2
VIDEO1
VIDEO2
VIDEO3
OSD
11 (1~22)
21 (1~23)
OFF (OFF/ON)
OFF (OFF, 5~20)
OFF (OFF, V1/V2/V3)
= RGB
= DVI1
= DVI2
= VIDEO1
= VIDEO2
= VIDEO3
= R5B
= DVI1
= DVI2
= VIDEO1
= VIDEO2
= VIDEO3
key several times to return the cursor to the sig-
20
2. ADJUSTMENTS
SYSTEM