Table of Contents
Advertisement
1
5
3
Figure 3
1. Carriage bolt, 3/8 x 1 in.
2. Lock nut, 3/8 in.
3. Carriage bolt, 1/2 x
1–1/4 in.
5. Install the tow hitch extension to the tractor using 2
bolts (1/2 x 1–1/4 in.) and 2 locknuts (1/2 in.) (Fig. 4).
2
Figure 4
1. Bolt, 1/2 x 1–1/4 in.
2. Lock nut, 1/2 in.
Installing the Collector Drive
1. Remove the mower. Refer to the mower operators
manual.
2. Install the jack shaft assembly inside the tractor frame
with 2 bolts (1/4 x 1 in.), 2 carriage bolts (5/16 x 1 in.),
2 locknuts (1/4 in.), and 2 locknuts (5/16 in.) (Fig. 5).
2
4
m–5966
4. Lock nut, 1/2 in.
5. Quick hitch
1
3
m-5965
3. Tow hitch extension
1
2
Figure 5
1. Bolt, 1/4 x 1 in.
2. Carriage Bolt, 5/16 x 1 in.
3. Locknut, 1/4 in.
3. Unplug the clutch terminal and remove the electric
clutch and the engine pulley (Fig. 8). Save the washer
and discard the bolt.
4. Remove the clutch stop from the frame of the machine
(Fig. 6).
5. Install the new shim/upstop and clutch stop to the frame
with 2 bolts (5/16 x 1–1/2 in.) and 2 lockwashers (Fig.
6).
m-5948
Figure 6
1. Bolt, 5/16 x 1–1/2 in.
2. Lock washer, 5/16 in.
6. Install the drive belt around the jack shaft pulley. Do not
put it around the drive belt idler (Fig. 7).
7. Loosely, install both the drive belt and transaxle belt
around the engine pulley (Fig. 7).
7
3
4
2
1
5
m-5950
4. Locknut, 5/16 in.
5. Jack shaft
3
2
4
1
3. Shim/upstop
4. Clutch stop
Advertisement
Table of Contents
