Removing The Bagger; Transporting The Machine - Toro 31211 Operator's Manual

6. Use a stick or similar object, not your hands, to remove
and clear the obstruction from the tube assembly.
Note: In most cases, the debris can be shaken out of
the tubes.
7. If the blower assembly is plugged, unlatch the bagger
blower assembly, remove the belt, and swing it open.
8. Use a stick or similar object, not your hands, to remove
and clear the obstruction from the blower assembly.
9. After you remove the obstruction, install the complete
bagger system and resume operation.

Removing the Bagger

WARNING
Components around engine will be hot if the
machine has been running. Touching hot
components can cause burns.
• Do not touch engine components when hot.
• Allow engine to cool before removing the bagger.
1. Disengage the PTO, set the parking brake, and chock
or block the tires.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch the lower tube from the blower and remove
the tube from the blower assembly.
4. Remove the tube from the bagger hood.
5. Lower the mower deck to the lowest height-of-cut
position.
6. Unlatch the belt cover over the mower-pulley assembly.
7. Remove the bagger belt from the mower-pulley
assembly.
8. Open the blower assembly.
9. Remove the blower assembly from the pivot hole.
10. If you are changing to side discharge mode, ensure that
the grass deflector is installed and can be lowered into
working position.
11. Remove the hood and bag assembly.

Transporting the Machine

Do not leave grass or debris in the bagger while transporting
the machine.
DANGER
Transporting the machine with grass or debris in
the bagger can damage the machine.
Do not leave grass or debris in the bagger while
transporting the machine.
10