Pasting Clipboard Data - Fostex MR16 Owner's Manual

Pasting clipboard data

The following procedure is assumed that the
LOCATE A point, the paste destination, is set
1) Rotate the [MENU/ENTER] knob to select
"Paste Part >", and press the [MENU/ENTER] knob.
The display now shows the screen for
selecting the paste destination track(s).
2) Rotate the [MENU/ENTER] knob to select
"Paste Track = *", and press the [MENU/ENTER]
knob.
You can now select the desired paste destination
track(s) by rotating the [MENU/ENTER] knob.
You can select the same number of tracks as the
paste destination track(s). For example, if you
select a mono track for the copy source, you can
only select a mono track for paste destination.
3) Rotate the [MENU/ENTER] knob to select the
paste destination track(s), and press the
[MENU/ENTER] knob.
The display returns to the previous screen.
4) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes the paste operation.
If you want to cancel the part paste operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] knob.
<Note>:
paste operation when no data is pasted on
the clipboard, the error message (" Clipboard
Empty! ) is shown on the display and the
MR16 does not accept the operation.
Press the [ STOP ] key to exit the menu mode
and copy the desired data to the clipboard
before carrying out the paste operation.
Flashing
5) After pressing the [MENU/ENTER] knob, press
the [STOP] key to exit the MENU mode.
<Note>:
sult, press the [ UNDO/REDO ] key to undo the
operation (see page 127).
Flashing
133
MR16
Owner's Manual (Part editing)
If you are going to carry out the
If you are not satisfied with the re-