Rear Panel Operations - Extron electronics MAV Plus Series User Manual

Crosspoint 450 plus series, crosspoint ultra series, mav plus series
Hide thumbs Also See for MAV Plus Series:
Table of Contents

Advertisement

2.
Release the Control buttons.
N The serial port settings are protected when front panel Lock mode 2 is selected.
3.
To change a value, press and release the button that relates to the desired
value (figure 3-80).
Press and release the button(s) to configure the port as
follows:
Baud rate:
Enter — 9600
View — 38400
Serial protocol:
RGBHV/Video — RS-232
The selected buttons blink and the others remain lit.
In this example, the port is set to RS-422 at 38400 baud.
ENTER
Figure 3-80 — RS-232/RS-422 and baud rate selection
4.
Press and release an output button to exit the Serial Port Selection and
Configuration mode (figure 3-81).
Press and release an
input or output button.
Figure 3-81 — Exit Serial Port Selection and Configuration mode

Rear Panel Operations

The rear panel has a Reset button that initiates four levels of resets
(numbered 1, 3, 4, and 5 for the sake of comparison with an Extron IPL
product). The Reset button is recessed, so use a pointed stylus, ballpoint
pen, or Extron Tweeker to access it.
See the following table for a summary of the modes.
C
N The reset modes listed below close all open IP and Telnet connections and close
You can view the settings in Lock mode 2 but you cannot change them from
the front panel. See "Setting the front panel Locks (Executive modes)" on
page 3-52.
If front panel Lock mode 2 is selected and you try to perform step 3, the actions
are ignored and the Enter, Video, and Audio buttons flash.
Preset — 19200
Esc — 115200
Audio — RS-422/RS-485
C O N T R O L
VIEW
ESC
RGBHV AUDIO
PRESET
All Control and I/O buttons return to unlit or background illumination.
5
ENTER
Review the reset modes carefully. Using the wrong reset mode may result
in unintended loss of flash memory programming, port reassignment, or a
controller reboot.
all sockets. Also, the following modes are separate functions, not a continuation
from Mode 1 to Mode 5.
CrossPoint / MAV Matrix Switchers • Operation
I / O
C O N T R O L
I / O
VIEW
ESC
PRESET
RGBHV AUDIO
3-55

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ultra seriesMav plus 164 aMav plus 168 hdMav plus 168 hdaMav plus 168 svMav plus 168 sva ... Show all

Table of Contents