Table of Contents
Advertisement
Using presets
The current configuration (configuration 0) can be saved as a preset in any one
of 64 preset memory addresses. Presets can be saved and recalled from the front
panel. The preset locations are assigned to input buttons 1 through 64. When a
preset is retrieved from memory, it becomes the current configuration.
N •
Presets cannot be viewed from the front panel unless recalled as the current
configuration. Presets can be viewed using Extron's Windows-based control
program. See chapter 5, "Matrix Software", for more details.
•
The current configuration and all presets are stored in non-volatile memory.
When power is removed and restored, the current configuration is still active
and all presets are retained.
•
When a preset is recalled, it replaces the current configuration, which is lost
unless it is also stored as a preset. The recalled preset overwrites all of the
current configuration ties in favor of the preset configuration ties.
Example 6: Saving a preset
In the following example, the current configuration is saved as a preset. The steps
show the front panel indications that result from your action.
1.
Clear all selections: Press and release the Esc button.
Press the Esc button to clear all selections.
C O N T R O L
ENTER
PRESET
The button flashes once.
2.
Select Save Preset mode: Press and hold the Preset button for approximately
2 seconds until it blinks.
2 seconds
PRESET
Press and hold the Preset button until it blinks.
All input buttons with assigned presets light.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
3.
Select the preset: Press and release the input button for the desired preset.
Press and release the Input 1 button.
The button blinks to indicate that this
preset number is selected but not saved.
1
2
17 18 19 20 21 22 23 24 31 32
VIEW
ESC
PRESET
INPUTS
3
4
5
6
7
8 15 16
Fiber Matrix 6400 Switcher • Operation
Lit
(preset assigned)
1
2
3
16
17 18 19 32
Unlit
(no preset assigned)
C O N T R O L
ENTER
PRESET
VIEW
ESC
The Enter button blinks to
indicate the need to save the
preset.
The Preset button continues
to blink.
3-21
Advertisement
Table of Contents
