Trane Exergy S 180 Installation And Operation Manual page 10

Preparations for storage, transfer, and lifting
1. Check that the way is free from obstacles.
2. Use appropriate vehicle for transport.
3. At installation site check that you have proper means and resources for lifting and
placing the pump.
Storage
Before transporting to the final installation site and commissioning phase, the heat
pump must not be stored longer than needed. If the heat pump must be stored longer
than one month, the manufacturer must be informed. The heat pump must be stored in
a dry place where the temperature is at least +5 °C.
Transfer (models S, RE, P 220 - 450)
● Move the heat pump with a forklift or two pallet jacks.
● Keep the heat pump in a vertical position.
● When using pallet jacks, place one on each side of the pump.
Lifting
S 180 - S 580:
There are welded lifting supports in the pump frame, see illustration.
Lifting brackets ver. 1
A and B, lifting supports
Use a forklift or a pallet jack to lift the heat pump as indicated by the labels and
markings on the device.
8 (66)
Do not transfer or lift the heat pump without any housing covers.
EXES01 2150EN