First Start-Up - Trane Exergy S 180 Installation And Operation Manual

8. Switch on the power.
9. Check the DC supply voltage.
10. Check the cooling fans and filters in the control cabinet. Check the variable
frequency drives' fans and filters (if present). Start the cooling fans by lowering the
cabinet's internal temperature setpoint. Note down the original setting and reset
after testing.
11. Check that the communication interface is connected and correctly set up.
Refer to the instructions and settings in the Modbus communication list.
12. Check the settings of any overcurrent protective devices.

4.7 First start-up

Set the language, time, and time zone.
Tap the right arrow to continue.
32 (66)
The screens shown below are discussed in further detail in chapter
Operation.
EXES01 2150EN