Cold Side Settings And Warm Side Settings - Trane Exergy S 180 Installation And Operation Manual

Timed setpoint ver. 2
Pos.
1 Primary side button and
setpoint
2 Secondary side button
and setpoint
3 Day selection buttons
4 Hour on and Hour off
To set up a weekly schedule, select the days on which the timed setpoint should apply.
Then, specify the hours between which the temporary setpoint will be active. In the
figure above, the setpoint will be used on Mondays and Tuesdays between 8 AM and 4
PM.

5.8 Cold side settings and warm side settings

The Cold side settings and the Warm side settings view are nearly identical. These
views will be used to specify the control method for the system's external circuits as
well as the medium used in the circuits. These control settings need to be selected for
optimal heat pump operation and to avoid the heat pump from operating outside its
operating envelope.
The views include a number of on/off buttons. Active buttons are shown in green.
EXES01 2150EN
Item
When the setpoint is active, the button is shown in green. To activate
and deactivate the setpoint, tap the button. Change the setpoint by
tapping the setpoint value.
Select the days on which the timed setpoint will be applied. The
selected days are shown in green.
Select the time of day at which the timed setpoint will be activated
(Hour on) and deactivated (Hour off).
Description
51 (66)