Operation; Pressure Relief Procedure - Graco Reactor 3 E-20 Elite Operation

Operation

Operation
Operation Operation
Pressure Pressure Pressure Relief Relief Procedure Relief
Follow the Pressure Relief Procedure
whenever you see this symbol.
This equipment stays pressurized until
pressure is manually relieved. To help prevent
serious injury from pressurized fluid, such
as skin injection, splashing fluid and moving
parts, follow the Pressure Relief Procedure
when you stop spraying and before cleaning,
checking, or servicing equipment.
1. If If If using using pneumatic pneumatic transfer
using pneumatic
air to the transfer pumps. See your pump
manual, Related Manuals, page 3
2. Tap to turn off the motor.
NOTE: NOTE: Electric transfer pumps will NOTE:
automatically turn off with the motor.
3. Tap ,
turn off all heat zones.
4. Relieve pressure in the gun and perform
the gun shutdown procedure. See your gun
manual, Related Manuals, page 3
5. Engage the gun piston safety lock.
The Fusion AP gun is shown.
30
Procedure Procedure
transfer pumps, pumps, turn off
transfer pumps,
.
, and
.
6. Close the gun fluid inlet valves A and B.
The Fusion AP gun is shown.
7. Shut off the transfer pumps and agitator, if
used.
For pneumatic pneumatic transfer
For For pneumatic
refer to your component manuals. See
Related Manuals, page 3
For electric electric transfer
For For electric
tap
transfer pump power, and
off the B-side transfer pump power.
NOTE: NOTE: The ADM software automatically turns NOTE:
off the transfer pumps if the system is in
Spray Spray Spray mode.
Manually turn off pumps that are in Jog
mode.
8. Ensure bleed or circulation lines are correctly
to
routed to waste containers or supply tanks.
Turn the pressure relief/spray valves (SA,
SB) to pressure relief/circulation
the gauges drop to 0.
transfer pumps pumps and and agitators
transfer pumps and
.
transfer pumps pumps (if (if (if necessary) necessary),
transfer pumps necessary)
to turn off turn off the A-side
agitators,
agitators
to turn
Jog
Jog
. Ensure
3A8500A