Shutdown - Graco Reactor 3 E-20 Elite Operation

Shutdown

Shutdown Shutdown
NOTICE
NOTICE NOTICE
Proper system Setup, Startup, and Shutdown
procedures are critical to electrical equipment
reliability. The following procedures ensure
steady voltage. Failure to follow these
procedures will cause voltage fluctuations that
can damage electrical equipment.
1. If If If using using pneumatic pneumatic transfer
using pneumatic
air to the transfer pumps. See your pump
manual, Related Manuals, page 3
2. Tap to turn off the motor.
NOTE: NOTE: NOTE: Electric transfer pumps will
automatically turn off with the motor.
3. Tap ,
turn off all heat zones.
4. Follow the Pressure Relief Procedure, page
30.
Pump Mode Mode button
5. Tap the Pump Pump Mode
Park mode from the drop down menu.
6. Select Park Park
Park mode is engaged when the motor
and transfer pumps are off, and a green
check appears next to the Park mode icon
.
Verify that Park mode is engaged before
moving to the next step.
NOTE: NOTE: NOTE: Electric transfer pumps will
automatically park at the bottom of their
stroke when the system is in Park mode.
3A8500A
transfer pumps, pumps, turn off
transfer pumps,
.
, and
7. Turn off the air compressor, air dryer, and
breathing air.
8. Turn the main power switch (MP) OFF.
9. Close all fluid supply valves.
to
10. Set the pressure relief/spray valves (SA, SB)
.
to spray
drain line.
11. Engage the gun piston safety lock then close
fluid inlet valves A and B.
Fusion
Fusion Fusion
Operation
to seal out moisture from
Probler
Probler Probler
39