Calibration - Graco Reactor 3 E-20 Elite Operation

Operation

Calibration

Calibration Calibration
Calibrate Calibrate the Calibrate the Heated the Heated Heated Hose
NOTICE
NOTICE NOTICE
To prevent damage to the heated hose, a hose
calibration is required if any of the following
conditions are true:
• The hose has never been calibrated before.
• A section of hose has been replaced.
• A section of hose has been added.
• A section of hose has been removed.
NOTE: The Reactor and heated hose must be at
NOTE: NOTE:
the same ambient temperature to get the most
accurate calibration.
1. Tap . Go to Setup Setup > Heat Setup
Calibrate
2. Tap Calibrate Calibrate
Continue
3. Tap Continue Continue
the reminder to have the hose at ambient
conditions.
4. Wait while the system measures the hose
resistance.
NOTE: NOTE: If hose heat was on prior to the NOTE:
calibration procedure, the system will
wait up to five minutes to allow the wire
temperature to equalize.
5. Tap Accept Accept Accept
calibration, or Cancel Cancel Cancel
calibration.
NOTE: NOTE: A temperature estimate will be NOTE:
displayed if the system was able to measure
the hose wire resistance.
36
Hose Hose
Heat. Heat
.
to acknowledge
to proceed with the
to stop the
Calibrate the Calibrate Calibrate the Transfer the Transfer Pumps Transfer
After installing a new electric transfer pump,
you must calibrate the transfer pump motor.
1. Tap . Go to Setup Setup > Supply Setup
2. If the transfer pump type is set to Electric
change the transfer pump type to Air
the Transfer Transfer Pump Transfer Pump Pump (A (A (A or or or B) B) B) Type
Air.
Air Air
3. Change the transfer pump type from Air
Electric Electric. Tap the Transfer Electric Transfer Pump Transfer
Electric.
field. Select Electric Electric
NOTE: NOTE: Changing the transfer pump type NOTE:
from Air Air to Electric Air Electric Electric triggers the calibration
function.
4. If If If calibrating calibrating calibrating both both transfer both
steps 2–3 for the other transfer pump motor.
5. Confirm there is no or low inlet pressure
in the transfer pump by opening the
recirculation lines (R).
6. Turn on the transfer pumps. The transfer
pumps will slowly move for multiple strokes
and then shift into normal operation.
a. To turn on the transfer pumps
individually: Tap
on the A-side transfer pump or tap
to turn on the B-side transfer
pump.
b. To turn on both transfer pumps with
the system: Tap
the motor. Electric transfer pumps will
automatically turn on with the motor.
Pumps Pumps
Supply System Supply System System.
Electric Electric,
Air. Tap
Air
Type field. Select Type
Air to
Air
Pump Pump (A (A (A or or or B) B) B) Type
transfer pumps, transfer pumps, repeat pumps,
to turn
to turn on
3A8500A
Type Type