Home Screen - Graco Reactor 3 E-20 Elite Operation

Home

Home Screen

Home Screen Screen
Use the Home screen to control the Reactor
system operation functions.
Temperature Temperature Temperature Control Control Panel Control
The Temperature Control panel contains
controls for Hose heat and A and B-side Primary
heaters.
Icon Icon Icon Name Name Name
Primary
Heater A
On/Off
Primary
Heater B
On/Off
Hose Heat
On/Off
A (ISO)
Tempera-
ture Set-
point
B (RES)
Tempera-
ture Set-
point
Hose
Current
Setpoint
Reset Auto
Pressure
Balance
Tempera-
ture Offsets
3A8500A
Panel Panel
Description Description Description
Tap to toggle the A primary heater
state.
Tap to toggle the B primary heater
state.
Tap to toggle the hose heat state.
Tap +/– to adjust the setpoint by
one degree. Press and hold +/- to
rapidly adjust the setpoint. Tap the
number to open a pop-up and type
in the setpoint directly.
Tap +/– to adjust the setpoint by
one degree. Press and hold +/- to
rapidly adjust the setpoint. Tap the
number to open a pop-up and type
in the setpoint directly
Tap +/– to adjust the setpoint by
one amp. Press and hold +/– to
rapidly adjust the setpoint. Tap the
number to open a pop-up and type
in the setpoint directly.
NOTE: The Hose Current Setpoint
NOTE: NOTE:
button is only displayed if the Hose
Control Mode is set to Manual in
the Setup, page 44 settings.
Tap to reset the Auto Pressure
Balance temperature offset values
(to the left and right of this button).
Advance Display Module (ADM)
A A A and and B B B side and side Supply side Supply Control Supply
The A and B Supply Control panels display the
remaining material supply for A and B side
materials, and contains controls for electric
transfer pumps (if applicable).
Icon Name
Icon Icon Name Name
Electric
Transfer
Pump A
On/Off
Electric
Transfer
Pump B
On/Off
A (ISO)
Transfer
Pump Jog
Level
B (RES)
Transfer
Pump Jog
Level
Control Panels Control Panels Panels
Description
Description Description
Press to toggle the A electric
transfer pump state.
NOTE: This button is only
NOTE: NOTE:
displayed if an electric transfer
pump is installed and the
proportioner pump state is off.
The electric transfer pumps are
automatically turned on any
time the proportioner pump is
turned on.
Press to toggle the B electric
transfer pump state.
NOTE: NOTE: This button is only NOTE:
displayed if an electric transfer
pump is installed and the
proportioner pump state is off.
The electric transfer pumps are
automatically turned on any
time the proportioner pump is
turned on.
Tap +/– or the displayed jog
level number (i.e. J10) to set
the A-side transfer pump jog
level.
NOTE: NOTE: Jog levels are between 1 NOTE:
and 20. Jog Mode, page 31.
Tap +/– or the displayed jog
level number (i.e. J10) to set
the B-side transfer pump jog
level.
NOTE: NOTE: Jog levels are between 1 NOTE:
and 20. Jog Mode, page 31.
41