Install Cell Module - Graco Reactor 3 E-20 Elite Operation

Install Cell Cell Module Module
Install Install Cell Module
NOTE: Installation of the cell module is required NOTE: NOTE:
to use the Reactor Connect app.
NOTE: The cell module is an optional accessory,
NOTE: NOTE:
and is included with Reactor Pro and Elite
models.
1. Turn the main power switch (MP) OFF.
Disconnect incoming power at the source.
2. Open the electrical enclosure door.
3. Remove the cardboard insert from the cell
module mounting location.
NOTE: NOTE: Removal of the cardboard insert NOTE:
acknowledges the understanding of the
Reactor Owner's Manual, Reactor Connect
app Terms and Conditions, and Reactor
Connect Privacy Notice.
4. Install the cellular module in the cell module
mounting location using the supplied nuts.
3A8500A
5. Attach the cellular antenna cable (ZE) to the
cellular module. Tighten by hand.
6. Attach the GPS antenna cable (ZD) to the
cellular module. Tighten by hand.
7. Attach the serial communication cable (ZF)
from the ADM (G) to the cellular module.
8. Close and lock the electrical enclosure door
with the door latches.
ZE
ti39867a
ZD
ZF
Setup
25