Installing/Removing Power Supply Modules - Siemens SIMATIC NET RUGGEDCOM MX5000RE Installation Manual

Rugged multi service platforms
Hide thumbs Also See for SIMATIC NET RUGGEDCOM MX5000RE:
Table of Contents

Advertisement

5.
6.
7.
Installing a Line Module
To install a line module, do the following:
1.
2.
3.
4.
5.
6.
7.
4.3

Installing/Removing Power Supply Modules

The RUGGEDCOM MX5000 supports dual redundant power supplies that can be
installed in any combination.
RUGGEDCOM MX5000RE
Installation Manual, 01/2021, C79000-G8976-1060-13
Install a new module or a blank module (to prevent the ingress of dust and dirt).
[Optional] If necessary, install the device in the rack.
For control and switch modules only, connect power to the device.
For Control and switch modules only, make sure power to the device has been
disconnected and wait approximately two minutes for any remaining energy to
dissipate.
[Optional] If the device is installed in a rack, remove it from the rack.
Remove the current module from the slot.
Insert the new module into the slot.
1
2
3
Chassis
1
Module
2
Screw
3
Figure 4.4
Installing a Module
Tighten the screws to secure the module.
[Optional] If necessary, install the device in the rack.
For control and switch modules only, connect power to the device.
4.3 Installing/Removing Power Supply Modules
Modules
39

Advertisement

Table of Contents
loading

Table of Contents