Installing The Front Panel; Mounting The Ruggedcom Mx5000Re - Siemens SIMATIC NET RUGGEDCOM MX5000RE Installation Manual

Installing the Device
2.13 Installing the Front Panel
2.13

Installing the Front Panel

To install the front panel for the RUGGEDCOM MX5000RE, do the following:
1.
2.
3.
2.14

Mounting the RUGGEDCOM MX5000RE

To mount the fully assembled RUGGEDCOM MX5000RE to its final mounting surface,
do the following:
1.
26
Position the RUGGEDCOM MX5000RE with the front opening facing up.
Figure 2.15 Front Panel Installation
WARNING
Crushing hazard – risk of serious injury or damage to equipment
Make sure the front panel is properly supported at all times. It is highly
recommended to employee the assistance of another technician.
Position the front panel over the RUGGEDCOM MX5000RE opening, aligning the
panel with the two (2) locating pins on the front face.
Secure the front panel with 24 screws. Hand-tighten the screws evenly in a cross
pattern.
Make sure the mounting surface is flat within a tolerance of 0.254 mm (0.010
in).
RUGGEDCOM MX5000RE
Installation Manual, 01/2021, C79000-G8976-1060-13